Electrical Remote Control Roller Blind

Electrical Remote Control Roller Blind System -

Operation Instructions:
Usually upward and downward limited positions of the blind were presetted by factory. You may reset these positions as the following steps.

(1) is a button of moving down and stop.
(2)  is a button of moving up and stop.
(3) The setting of downward limited and upward limited positions are as:
(a) You MUST set the downward limited position first.
(b) Press the SET button for 6 seconds till the red light flush and release the button.
(c) Click the button, the blind will go down till to the desired downward limited position and click the same button again to stop the blind.
(d) Click the CONFIRM button to confirm the downward limited position.
(e) Click the  button, the blind will go up till to the desired upward limited position and click the same button again to stop the blind.
(f) Click the CONFIRM button to confirm the upward limited position. The red light will change to green light and stop to flush. The setting is completed now.
(4) You can click the or  button, the blind will go down or up to your desire position within you presetted downward and upward limited position, please keep trying.
(5) Small button of R & S are changed the current. The meaning is changed the rolling direction of the blind.
(6) Use a small stick to press the button R for few seconds till to red light flush and then press button S till to the red light changed to green light. This setting is completed.

Technical Specification

- Input Voltage: 220V/50Hz or 110V/60Hz
- Output Voltage: 24VDC
- Power Consumption: 10W
- Maximum Remote Control Distance: 12M
- Turning Speed: 28 sec/M
- Maximum Curtain Weight: 8 kgs
- Aluminium Tube: 32mm dia.
- Length Up to 1.5M